UV Gel Base Coat, UV001

1. NAIL PREPARATION
Shape the natural nail plate to the desired shape.
Clean the nail surface with a cotton pad soaked in Wild&Mild Gel Polish Cleanser & Remover to remove any moisture, grease & dust from the nail plate. It is important to provide a good wear time of the gel polish.

2. BASE COAT
Apply one thin coat of Wild&Mild UV Gel Polish Base Coat & cure it under the Wild&Mild LED Lamp for 60 seconds. Please note that the surface will remain sticky after curing with the LED lamp; this is completely normal. Do not touch or remove the sticky layer. Make sure the gel product does not touch the cuticle or skin around the nail, as it may cause lifting. If you accidentally apply some product on the skin, remove it carefully with an orangewood stick.

3. COLOR COAT
Apply one thin coat of your favourite Wild&Mild UV Gel Polish Color Coat on your nails & cure under the Wild&Mild LED Lamp for 60 seconds. When all nails are lacquered & cured with the lamp, apply the second coat of color coat & cure under the LED lamp for 60 seconds. Please note that the surface will remain sticky after curing with the LED lamp; this is completely normal. Do not touch or remove the sticky layer.

4. TOP COAT
Apply a thin layer of Wild&Mild UV Gel Polish Top Coat on your nails & cure under the Wild&Mild LED Lamp for 120 seconds. No sticky layer will remain.

Warnings: Keep out of the reach of children. Irritating to eyes, respiratory system & skin. In case of contact with eyes, rinse immediately with plenty of water & seek medical advice. Avoid contact with skin. May cause an allergic reaction. If any adverse reaction occurs, stop using the product.